All,

Had my car baselined at Performance Factory in Orlando, FL on a dynojet.

Numbers were 268rwhp and 237rwtq! Just to see what would happen we removed the air filters and there was no change. Also removed the exhaust and ran open cats, and power went up to 276rwhp!

Can't wait to get my exhaust and test pipes... Will have it dynoed again then.

 

Nice!

 

Awesome... pretty impressive stock numbers!

What plans do you have other than exhaust?

 

Well there isn't a whole lot out.... exhaust mods should give me 18rwhp minimum. Then maybe some k&n drop in's..... JWT cams when they come out and a UTEC tune (if that ever comes out) That should all be 300rwhp hopefully on a dynojet.

 

very very nice numbers! The stock one we dynoed did 245whp on the DD, so that 268whp sounds about right on the DJ. Seems the 07's are more consistent than the 03-06's.

 

Awesome! I wonder if I actually gained that much with my exhaust. I can't wait for more mods to come out - my mod plans are very similar to yours.

 

damn.. that's high!

 

I wonder how much will just nismo exhaust add without removing cats

 

not shabby at all.
Putting test pipes in place of the cats should make a nice difference.

 

Nice baseline!

 

plan on a dyno this weekend if I get some time.

 

and to think a wasted all that money and i only have 266whp

 

Deffinately promising numbers. Test pipes should make quite a bit more too I would think.

 

I'll be getting my testpipes monday so i would contribute to this thread with 07 w/testpipe dyno.

 

^^^ Yes please do before and after dynos! The test pipes you're getting monday are they 07 specific or are they 03-06 that you are modifying?

thanks.

 

i wish they were 07's they're 03-06 and well i'm just hoping they cut modify those flanges and hopefully they could weld Stainless steel.. you know down here in miami things could get getto sometimes.

 

^^^ oh you're just "hoping", I would make sure it could be done. I was going to have mine installed and Performance Factory couldnt do it cause their welder wouldnt mess with the cats. So you'll only be getting test pipes put in, I cant wait to see before and after dynos with just the test pipes, also want to hear the sound too...

 

well i was hoping to not touch my cats pull them out and just have the shop modify the actual TP and the flanges or make new flanges to make them fit.

 

Nice numbers.

 

Nice numbers.